Author |
Message |
Bruno Giordan
|
Posted: Thu 13 Aug, 2009 2:27 am Post subject: |
|
|
Michael Pikula wrote: | Adam S. wrote: | I'd like an opinion.
Does it look as if the pommel may have had wire work? There are two fairly pronounced pits near the base of the central lobe that look like they could have either been recesses for then ends of wire, or just deep pitting.
I can't remember where I got this image, but I believe it's from the Yorkshire Museum. Same as the first. |
I think the holes are actually pitting from where it corroded through.... I could be off though. |
from the holes there is apaprently some light coming iout, it appears as an hollow pommel, a fusion likely,: this could explain why the balance point is so far off the hilt,, along with a lack of distal taper.
It would be fundamental to have some distal taper data for both blade and tang.
|
|
|
|
Dave W.
|
Posted: Fri 14 Aug, 2009 10:55 am Post subject: |
|
|
Thanks Nathan
|
|
|
|
Jared Smith
|
Posted: Fri 14 Aug, 2009 4:19 pm Post subject: |
|
|
Bruno Giordan wrote: | ,: this could explain why the balance point is so far off the hilt,, along with a lack of distal taper.
It would be fundamental to have some distal taper data for both blade and tang. |
Given the kind of discrepancies/possibilities in different datings in the background of the writing, find, etc., I am wondering if anyone considers it possible that this was an older blade that was later rehilted?
Absence of evidence is not necessarily evidence of absence!
|
|
|
|
Peter Lyon
Industry Professional
|
Posted: Sat 15 Aug, 2009 2:04 pm Post subject: |
|
|
Just a further note about the Cawood sword, the pommel is actually very thin (maybe only 8-10mm in the detail area and a little thicker in the base of the pommel) - so the holes could well be showing the top of the tang inside the pommel. Whether they are corrossion, or were for wires to be pushed into, there is no trace now to confirm either way. Before anyone asks, I can't post the photos I have as I had sign an agreement that requires permission from the museum before I publish them anywhere.
This pommel is more about decoration and leverage for the hand, than counterweight, it would weigh no more than 150 grams (about 6 ounces). One of the reasons it felt so good in hand, I think, is that the short grip (85mm) held my hand snuggly between the cross and pommel base, and probably allowed me more leverage with the sides of my hand than if my only contact was the tang. Another aside, I have long fingers but an average sized hand, so there would not be much room to wear any sort of glove with this grip without feeling pinched.
Still hammering away
|
|
|
|
Adam S.
|
Posted: Sat 15 Aug, 2009 2:15 pm Post subject: |
|
|
Thanks for that, Peter! More information is always welcome!
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum
|
All contents © Copyright 2003-2024 myArmoury.com All rights reserved
Discussion forums powered by phpBB © The phpBB Group
Switch to the Basic Low-bandwidth Version of the forum
|